sunnuntai 30. lokakuuta 2011

Protoilua perjantaina 28.10.2011

Perjantaina aloimme testailemaan uusien paineilmamuottien muotoja almamuovilla. Testasimme liitostekniikkaa, jolla muotti voitaisiin toteuttaa. Kuvia protoilusta:

--------------------------------------------

On Friday we started to work on the shapes of the new pneumatic molds. We used plastic as a material. We tested for example the possible joints of the plastic. Photos:

Ohjeita

Paperiprotoilua ennen kun siirryimme pajalle työskentelemään

Teipattu muotti

Täyttöä




Huomasimme, että saumat eivät tällä tekniikalla pitäneet täysin, joten liitokset täytyy teipata tarkemmin. Huomasimme myös, että paineilma herkästi rikkoo muovin, joten venttiilinä on parasta käyttää jotain muuta materiaalia. Muovi muutenkin herkästi rikkoontuu, joten täytettäessä täytyy varoa ettei roskat tai muut terävät esineet riko muottia. Huomasimme myös, ettei tällä muodolla saada täysin pyöreitä muotoja aikaan, joten sitä varten täytyy kokeilla erilaista mallia. Tosin, tällä muodolla voi saada mielenkiintoisia syvennyksiä ja muita muotoja muottiin.
---------------------------------------------------------------
We noticed, that the seams leaked so we have to tape them more carefully. Also the pressure of the air makes easily holes in the material. Therefore the valve should be made of some other material than this plastic. Also it is good to pay attention to the surroundings while filling the mold so that the rubbish or other sharp objects will not make holes in the mold.
This shape doesn´t make a round shape, so to make totally round mold we must try another construction. Although this shape allows to make other kind of interesting hollows and other shapes to the mold.


- Lapland Snow Design

Ei kommentteja:

Lähetä kommentti